There are four periods per each day, for Heat mode and Cool mode. They are: MORN, DAY, EVE, NITE. ALL 4 periods MUST be set for the thermostat to function properly. These same programming steps for all four periods below, must be performed independently in both Heat and Cool modes.
NOTE: This model has a user option to use only TWO periods instead of the default of FOUR. In the 2-period configuration, all of the following steps are the same except there will be only DAY and NITE periods present. NOTE-2: This model has a user option to be either programmable or non-programmable (manual). If the clock or period times are not shown, check for this setting.
TO SET THE WEEKDAY AND WEEKEND HEAT TEMPERATURE PROGRAM
FIRST: Select HEAT Mode. Move SET Slider to “TEMP PROG” (this will program all 7 days of the week, each day separately, in order of Mo, Tu, We, Th, Fr, Sa, Su).
MORN Period
DAY Period
EVE Period
NITE Period
Thermostat will now be on TUESDAY, MORN Period. Continue using the same NEXT, NEXT, NEXT process shown above for each of the remaining six days of the week if there are any time or temperature differences between individual days of the week.
MOVE THE SET SLIDER BACK TO THE RUN POSITION IF COMPLETE.
COPY HEAT PROGRAM TO REMAINING DAYS OF THE WEEK
If the Heating values entered for MONDAY are to be used for all the remaining days of the week, complete all of Monday and press NEXT until you move into TUESDAY. Once into Tuesday, press the COPY/EMER button one time. The screen will show COPY PROG, and then allow you to choose the day you would like to Copy “FROM”, flashing. Choose the Copy From day using the UP/DOWN buttons, than press NEXT one time to proceed. You will now choose the Copy “TO” day, which his flashing, using the UP/DOWN buttons.
Once you have selected the destination day, press the COPY/EMER button and the flashing destination day will automatically advance to Wednesday. Keep pressing COPY/EMER until the remainder of all the days of the entire week are complete and the display comes back around to TUESDAY flashing again. All seven days of the week will now have the same program periods for Heat mode.
MOVE THE SET SLIDER BACK TO THE RUN POSITION IF COMPLETE.
TO SET THE COOL TEMPERATURE PROGRAM
Move the temperature mode switch into the Cool position, and the SET Slider into the “TEMP PROG” position.
Repeat all of the same steps shown above in Heat Programming, for the Monday “MORN, DAY, EVE, and NITE” Cooling periods, for each of the 7 days of the week.
MOVE THE SET SLIDER BACK TO THE RUN POSITION IF COMPLETE.
COPY COOL PROGRAM TO REMAINING DAYS OF THE WEEK
If the Cooling values entered for MONDAY are to be used for all the remaining days of the week, complete all of Monday and press NEXT until you move into TUESDAY. Once into Tuesday, press the COPY/EMER button one time and MONDAY will remain solid with TUESDAY flashing. Press COPY/EMER and the flashing day will automatically advance into Wednesday. Keep pressing COPY/EMER until the remainder of all the days of the entire week are complete and the display comes back around to TUESDAY flashing again. All seven days of the week will now have the same program periods for Cool mode.
MOVE THE SET SLIDER BACK TO THE RUN POSITION IF COMPLETE.